Input / output type: DC input (drain / source).
Input points: 16 points.
Input and output points: 16 points.
Because all models of FX series are built in high speed counter,
So the high speed control can be realized by the simple procedure.
The input of the basic unit is built in the anti jitter filter,
One part as digital filter,
Sensitivity adjustment unit can reach 1ms MITSUBISHI FX2N-80MR-001 Manual FX2N-80MR-001
Using high speed counter automatically adjusted to the minimum value.
Through the high cost of the built-in positioning function and the expansion function to increase the number of control axis.
Extended function expansion board and special adapter,
Data links and communication with external serial devices.
FX2N extension module MITSUBISHI FX2N-80MR-001 Manual.
The expansion module is an input and output expansion device of the power supply from the basic unit or the expansion unit,
Can choose the relay or crystal output models, to 8 points for the unit to connect.
Can be extended to FX3GA/FX3G, FX3GE, FX3GC, as well as FX3U, FX3UC series,
When connecting to FX3UC or FX3GC, you need FX2NC-CNV-IF or FX3UC-1PS-5V.
The number of connection points depends on the basic unit and the expansion unit MITSUBISHI FX2N-80MR-001 Manual. Can be isolated to obtain DC24/48/100V, AC100/200V input signal.Power: 7.5kw.
Voltage: 200V.
The power factor of the input power factor is up to 0.99 and above (100% load).
Can be connected to multiple inverters, to achieve a common DC bus mode.
Equipped with standard power retrogradation function. Memory type: EEPROM.
Protection switch: have.
Program transfer function.
EEPROM memory can be connected to FX3SA, FX3GA, FX3GE do not need a battery backup and with the program transfer function.
Protective switch with incidental write protection,
Program transfer function between built-in PLC and memory box.
When the memory box is installed on the PLC host, the program in the memory box is preferred.
The memory box can be installed on the function expansion board and FX3S-CNV-ADP, FX3G-CNV-ADP. Power: 55kw.
Purpose: to suppress the power harmonics.
Improve the power factor, reduce the input side of the high harmonic current.
Make sure that this option is installed in the FR-A820-03800 (775K) and FR-A840-02160 (75K) and above capacity and above capacity FX2N-80MR-001 PROGRAMMING MANUAL II.
At the same time the installation options in the use of 75kW and above motor. (the IP55 series has a built-in DC reactor.)
According to the motorr power used to select the DC reactor FX2N-80MR-001 PROGRAMMING MANUAL II.
(when the inverter capacity is greater than the motor capacity, is still based on the motor capacity to choose.)