Analog input points: 8 channels
Voltage input range: DC-10~10V.
Current input range: DC4~20mA, DC-20~20mA.
The resolution of 14 bit binary + symbol 1 bit, 13 bit binary + symbol 1 bit analog input module.
Voltage input, current input, thermocouple temperature sensor input of the 8 channel can be carried out MITSUBISHI COMMUNICATION ADAPTER USER'S GUIDE.
The channel can be used as the unit, the mixed use of voltage, current, thermocouple input FX0N-232ADP Output points: 32 points.
Power supply: the basic unit to the expansion module to provide power.
Output form: transistor output (source).
Terminal type: connector type.
Weight: 0.2kg.
FX3GC, FX3UC can be directly connected to the input and output expansion equipment, to achieve a compact expansion MITSUBISHI COMMUNICATION ADAPTER USER'S GUIDE.
Can choose 16 points, 32 points of the relay or transistor input and output models.
FX2NC-16E_-T-DS for terminal units can be disassembled models. Input points: 32 points.
Output points: 32 points.
Output form: transistor.
Connected programmable logic controller: FX1NC, FX2NC, FX3UC.
FX2NC expansion module can be directly connected to the FX1NC, FX2NC, PLC FX3UC on the expansion of the input and output MITSUBISHI COMMUNICATION ADAPTER USER'S GUIDE.
Do not need to connect the cable and so on, therefore can carry on the compact expansion. MITSUBISHI inverter series: FR-F840.
Voltage level: three phase 400V.
Power: 2 FX0N-232ADP USER'S GUIDE. 2kw.
SLD converter rated current: 5.2A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
2 times the power consumption of the wind turbine and pump and the speed of the 3 power consumption is proportional to the speed of the rotating speed FX0N-232ADP USER'S GUIDE.
Through the speed control of the frequency converter to adjust the air flow, can reduce the power consumption.
Give full play to the performance of the motor.
The excitation current is always adjusted to the best state, which can improve the efficiency of the motor FX0N-232ADP USER'S GUIDE.
Load torque is smaller, can further improve energy efficiency.
For example, when a general motor is used, the optimal excitation control mode in the 4% motor load torque is about 30% more than that of the V/F control. MITSUBISHI inverter FR-D740 series.
Voltage level: three phase 400V.
Frequency converter capacity: 7.5KW.
The internal and back of the inverter structure considering the cooling effect, the relationship between the upper and lower ventilation is also important,
Therefore, in order for the type of unit, hanging on the wall to the vertical position, the installation of vertical as possible.
Transducer can be used to drive a single phase motor? Can single phase power supply be used?
Basically can not bee used FX0N-232ADP Manual. For a single phase motor with governor switch, the auxiliary winding will be burnt when the speed is below the operating point;
For the capacitor start or capacitor operation mode, the capacitor explosion will be induced MITSUBISHI COMMUNICATION ADAPTER USER'S GUIDE.
The inverter power supply is usually 3, but the capacity for small, single-phase power is also useful functioning aircraft.