Converts the built-in I/O function to the screw terminal.MITSUBISHI inverter series: FR-A820.
Voltage level: three phase 200V.
Power: 90kw.
SLD converter rated current: 475A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Parameters can be selected by 4 different rated current and different overload rating (SLD (ultra light load) rated, LD (light load) rating, ND (general load) rating, HD (weight) MITSUBISHI Positioning Control Training Manual FX SERIES
Type load) for selection.
You can choose the most suitable frequency converter for use; and by selecting a transducer with a SLD or LD rated level,
Be able to reduce the size of the device (compared with the FR-A700 series, to reduce the volume of equipment).
For applications that require high torque at low speeds, the HD rating is the most suitable MITSUBISHI Positioning Control Training Manual.
The controller is used to control and monitor the frequency converter through the network.
Standard corresponding RS-485 communication (MITSUBISHI converter protocol, Modbus-RTU protocol) data transmission speed up to 115200bps. Function expansion board for RS-422 communication.Needle number: 20.
Specification: loose wire connector, 5 sets (0 MITSUBISHI Positioning Control Training Manual. 3mm 2). Cable length: 0.5m.
RS-485 terminal unit conversion unit.
Applicable model: GT16. Master station module for CC-Link.
FX2N-16CCL-M is the PLC CC-Link as the FX master module FX SERIES Training Manual.
Up to 7 remote I/O stations and 8 remote stations can be connected to the main station.
Using the CC-LINK FX2N-32CCL interface, you can install PLC FX as CC-LINK remote device station to connect FX SERIES Training Manual.
In addition, through the connection of various equipment manufacturers, can be applied to a variety of purposes of the system.
The most suitable for production lines and other equipment control. Connecting cable for handheld RH GOT and PLC FX SERIES Training Manual.
Cable length: 10 meters.
Application: RS-422 connection and RS-232C connection. Signal level: the DC5V, 12V, and 24V differential output can be connected to the DC5V terminal by connecting terminals.
Applicable PLC:FX1N, FX2N, FX3U, FX2NC (to FX2NC-CNV-IF).
Appplicable PLC:FX3UC (to FX2NC-CNV-IF or FX3UC-1PS-5V) FX SERIES Manual.
Can be single phase, dual phase 50kHz hardware counter high-speed input.
High speed uniform output function with hardware comparison circuit.
In thhe dual phase count, 1, 2, and 4 multiplication modes can be set MITSUBISHI Positioning Control Training Manual.
Can be licensed and reset by PLC or external input.
Differential output type encoder.