The operation, monitoring, parameter modification and other operations can be carried out by computer or PLC.Power: 3.7kw.
Purpose: to suppress the power harmonics.
Improve the power factor, reduce the input side of the high harmonic current.
Make sure that this option is installed in the FR-A820-03800 (75K) and FR-A840-02160 (75K) and above capacity and above capacity MITSUBISHI FR-E740-016 to 300-EC Manual FR-E740-016 to 300-EC
At the same time the installation options in the use of 75kW and above motor. (the IP55 series has a built-in DC reactor.)
According to the motor power used to select the DC reactor.
(when the inverter capacity is greater than the motor capacity, is still based on the motor capacity to choose.) Input and output form: DC input, relay output MITSUBISHI FR-E740-016 to 300-EC Manual.
Input points: 4 points.
Output points: 8 points.
Because all models of FX series are built in high speed counter,
So the high speed control can be realized by the simple procedure.
The input of the basic unit is built in the anti jitter filter,
One part as digital filter,
Sensitivity adjustment unit can reach 1ms.
Using high speed counter automatically adjusted to the minimum value MITSUBISHI FR-E740-016 to 300-EC Manual.
Through the high cost of the built-in positioning function and the expansion function to increase the number of control axis.
Extended function expansion board and special adapter,
Data links and communication with external serial devices.
FX2N extension module.
The expansion module is an input and output expansion device of the power supply from the basic unit or the expansion unit,
Can choose the relay or crystal output models, to 8 points for the unit to connect.
Can be extended to FX3GA/FX3G, FX3GE, FX3GC, as well as FX3U, FX3UC series,
When connecting to FX3UC or FX3GC, you need FX2NC-CNV-IF or FX3UC-1PS-5V.
The number of connection points depends on the basic unit and the expansion unit. Input signal power: 40mA. DC24V
Axis of control: 1.
Output frequency: Max 200kHz.
Weight: 0.2kg.
FX3U-1PG is a pulse output module of the maximum output 200kHz pulse train.
7 operation modes needed to take the simple position control FR-E740-016 to 300-EC Installation GuideLINE.
The speed and the target address can be changed in the positioning operation according to the operation of the project,
Support near S shape plus deceleration. High sspeed positioning can be carried out smoothly FR-E740-016 to 300-EC Installation GuideLINE.
Up to 8 units can be connected to FX3U or FX3UC.
Connecting FX3UC requires FX2NC-CNV-IF or FX3UC-IPS-5V.