Memory card interface (AD59-MEF), parallel interface.
On-line debugging is the process that will through the simulation debugging to further carry on the on-line unification to adjust.
On-line debugging process should be step by step,
From MITSUBISHI PLC only connected to the input device, and then connect the output device, and then connect to the actual load and so on and so on step by step MITSUBISHI touch screen User's Manual A970GOT-SBD
If you do not meet the requirements, the hardware and procedures for adjustment.
Usually only need to modify the part of the program can be. Program memory capacity: 8k.
Input / output points: maximum 256 points.
With base plate and power supply.
PLC is the use of " sequential scanning, and constantly circulating " way to work MITSUBISHI touch screen User's Manual.
That is, in the operation of CPU, PLC according to the user according to the control requirements of the coexistence of the user in the memory of the program,
According to the instruction sequence number (or address number) for periodic cyclic scan, such as no jump instruction,
From the first instruction to the user program execution sequence one by one, until the end of the program,
And then return to the first command, start the next round of the new scan, in the process of each scan,
Also complete the sampling of the input signal and the output status of the refresh and other work MITSUBISHI touch screen User's Manual A970GOT-SBD User's Manual.
With the rapid development of microprocessor, computer and digital communication technology,
Computer control has been extended to almost all industrial fields A970GOT-SBD User's Manual.
Modern society requires manufacturing to respond quickly to market demand,
Production of small quantities, multi varieties, multi specifications, low cost and high quality products,
In order to meet this requirement,
Production equipment and automatic production line control system must have high reliability and flexibility,
PLC programming is to comply with the requirements of the emergence of it is based on a microprocessor based general industrial control device A970GOT-SBD User's Manual.
PLC programming is a digital computing operation of the electronic system,
Designed for applications in industrial environments.
It uses programmable memory,
An instruction used to perform logical operations, sequencce control, timing, counting and arithmetic operations in its internal storage,
And through the digital, analog input and output, control of various types of machinery or production process A970GOT-SBD Manual.
Programmable controlller and related equipment,
Should be easy to make the industrial control system to form a whole, easy to expand the principle design of its functions MITSUBISHI touch screen User's Manual.