MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 0.2kw.
Interface type: general pulse interface type.
Power specification: single phase AC100V.
Pulse train and analog input as universal interface.
Can choose the position, speed and torque control mode MR-J2-10B.
The use of advanced tuning features such as advanced vibrationn suppression control and adaptive filter,
Greatly improve the performance of the machine.
MR-J3, your partner.
Higher performance, more features, more convenient to use MR-J2-10B.
Highest performance in the industry.
Speed response frequency up to 2.1kHz. Superior high efficiency IPM motor.
Output power: 3.7kw.
Rated speed: 1500r/min.
Voltage level: 400V.
IPM motor MM-EFS series can not be used to run the power frequency power MR-J2-10B.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time.
MITSUBISHI general purpose AC servo amplifier MR-J2 series.
Rated output: 0.1kw.
Interface: SSCNET type.
Voltage: single phase AC200V MITSUBISHI MR-J2-10B.
MR-J2 series server system has the ability to carry out a higher precision control,
Using high performance CPU, greatly improve the responsiveness of the product,
Speed loop frequency response increased to 550HZ.
Various series of servo motors are suitable for different control requirements,
The encoder on the servo motor supports ABS mode,
As long as the servo amplifier on the other plus batteries,
Can form an absolute position system MITSUBISHI MR-J2-10B. Cable length: 0.5M.
Amplifier CC-Link interface unit cable.
For MR-J2S-11KA (4) MR-J2S-22KA to (4) MITSUBISHI MR-J2-10B.
Amplifier and CC-Link interface unit using 0.5 m (1.64 ft) or shorter cables. Only compatible with MR-J2S-CP1-S084.MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 0.1kw.
Interface type: CC-Link communication type (built-in positioning function).
Power specification: single phase AC100V.
Positioning operation by setting position and rotational speed data in the positioning table and receiving the start signal from the main controller.
The setting of the position and speed of the positioning table, as well as the start and stop operation can be completed through CC-Link communication.
By using the MR-J3-D01 extension IO unit, the DI/O instruction can be used to select and locate the table.
(CC-Link can not be used for MR-J3-D01 communications).
With built-in positioning function of the servo amplifier, can be set through the CC-Link communications and speed data. (corresponding to the CC-Link version: Ver.1.10)
Can be achieved through the CC-Link communications to start, stop and monitoring and other operations.
Serial communication reduce wiring.
Distributed servo control system can be built by CC-Link communication.
The parameters of unit MR-PRU03 (optional) the parameter setting, operation and monitoring more convenient MR-J2-10B.
The servo amplifier can be used for speed control operation.
When the two stations are occupied, the speed can be set directly by the remote register.