Servo motor series: medium inertia, small capacity.
Rated output: 2.0kw.
Rated speed: 2000r/min.
Electromagnetic brake: incidental.
Oil seal: incidental (Note 1, note 2, note 3).
Power supply: 200V.
Note 1 through HG-KR and HG-MR series 0.1kW and HG-SR series can be supported HA-FE13.
Note 2 with the speed reducer case, do not configure the oil seaal.
Note 3 with oil seal HG-KR, HG-MR series servo motor''s appearance size standard is different.
Stable driving of medium capacity and medium inertia type products HA-FE13.
Through the optimization of structural design, to achieve the minimum length of the industry.
High speed & high torque. Shorten the positioning time, achieve high-speed equipment.
Reducing the electric torque ripple.
Through the combination of the optimal number of the motor and the slot number, the torque ripple is greatly reduced,
To further realize the smooth constant speed device HA-FE13.
Improve the environmental performance of HG-SR, HG-JR series of products using IP67. Motor series: low inertia, small capacity.
Using a serial absolute / incremental encoder MITSUBISHI HA-FE13.
Rated output power: 0.6kw.
Rated speed: 3000rpm.
With the brake: without.
Shaft end: straight shaft.
AC servo motor and brushless DC servo motor in the function of the difference: AC servo is better, because it is a sine wave control, torque ripple small MITSUBISHI HA-FE13.
DC servo is a trapezoidal wave. DC servo is simple and cheap.
Type: HA-FE series.
Rated output: 0.1KW.
Rated speed: 3000r/min.
Electromagnetic brake: No.
Control complex, easy to achieve intelligent,
The electronic commutation method is flexible and can be changed by square wave or sine wave MITSUBISHI HA-FE13.
Motor maintenance free, high efficiency, low operating temperature,
Electromagnetic radiation is very small, long life, can be used in a variety of environments.
AC servo motor is brushless motor, which is divided into synchronous and asynchronous motor,
Synchronous machines are commonly used in motion control,
Its power range, you can do a lot of power.
Large inertia, the maximum rotation speed is low, and with the increase of power and rapid reduction.
So it is suitable for the application of low speed and stable operation.
The rotor of the servo motor is permanent magnet,
Drive controlled U/V/W three phase electric electromagnetic field,
The rotor rotates under the action of the magnetic field,
At the same time the motor comes with the encoder feedback signal to the drive,
According to the feedback value and the target value, the driver is compared,
Adjust the rotor rotation angle HA-FE13.
The accuracy of the servo motor is determined by the accuracy of the encoder.