Input and output points: 48 points.
AC power supply: AC100~240V.
Input points: 24 points.
Output points: 24 points.
Output form: relay output.
Weight: 0.85kg.
Input signal voltage: DC24V.
FX2N series expansion unit
Expansion unit is an input and output expansion device with a built-in power supply FR-D740-2.2K-CHT.
As with tthe basic unit, the extension unit can be connected to a variety of input and output and special extension equipment.
Can connect to FX3GA/FX3G, FX3GE and FX3U FR-D740-2.2K-CHT.
AC power model, the built-in maximum DC24V 250mA/460mA supply power.
Because all models of FX series are built in high speed counter,
So the high speed control can be realized by the simple procedure MITSUBISHI FR-D740-2.2K-CHT.
The input of the basic unit is built in the anti jitter filter,
One part as digital filter,
Sensitivity adjustment unit can reach 1ms FR-D740-2.2K-CHT.
Using high speed counter automatically adjusted to the minimum value.
Through the high cost of the built-in positioning function and the expansion function to increase the number of control axis MITSUBISHI FR-D740-2.2K-CHT.
Extended function expansion board and special adapter,
Data links and communication with external serial devices. Cable length: 1.5 meters.
For FXCPU (FX0, FX0S, FX0N, FX1S, FX1N, FX2N, FX2NC,) and GOT connection MITSUBISHI FR-D740-2.2K-CHT.
For FXCPU expansion board FX2N-422-B, FX1N-422-BD and GOT connection. Cable length: 1m.
RS-485 terminal unit conversion unit.
Applicable model: GT16. Analog input expansion board (2 channel).
Can be installed in FX1N, PLC FX1S, providing 2 channel analog input of the board.
Because it is embedded in the PLC installation, so do not need to install space.
Can be mixed with the use of voltage input and current input. Axis of control: 1.
Interpolation: No.
Program memory: built-in 3.8k step EEPROM.
Applicable PLC:FX1N, FX2N, FX3U, FX2NC (to FX2NC-CNV-IF).
Applicable PLC:FX3UC (to FX2NC-CNV-IF or FX3UC-1PS-5V).
Not only can deal with single speed positioning and positioning,
Can also carry on the multi section fast operation and so on complex control.
Can not be connected to the PLC, while running alone.
1 can control 1 axes,
FX1N, FX2N, PLC FX3U up to 8 units can be connected,
PLC FX2NC up to 4 units can be connected,
FX3UC PLC can connect up to 7 units, and a plurality of shafts can be independently controlled FR-D740-2.2K-CHT.
Can output up to 200kHz of the pulse train.
The connection function of the absolute position detection function and the manual pulse generator.
Can be used in the form of flow chart programming software, visual programming.