MITSUBISHI inverter series: FR-F840.
Voltage level: three phase 400V.
Power: 2.2kw.
SLD converter rated current: 5.2A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
2 times the power consumption of the wind turbine and pump and the speed of the 3 power consumption is proportional to the speed of the rotating speed MITSUBISHI FX3UC-16MT/DSS-P4 Manual.
Through the speed control of the frequency converter to adjust the air flow, can reduce the power consumption FX3UC-16MT/DSS-P4
Give full play to the performance of the motor.
The excitation current is always adjusted to the best state, which can improve the efficiency of the motor.
Load torque is smaller, can further improve energy efficiency.
For example, when a general motor is used, the optimal excitation control mode in the 4% motor load torque is about 30% more than that of the V/F control MITSUBISHI FX3UC-16MT/DSS-P4 Manual. Power: 30kw.
Voltage: 400V.
The power factor of the input power factor is up to 0.99 and above (100% load).
Can be connected to multiple inverters, to achieve a common DC bus mode.
Equipped with standard power retrogradation function. Input points: 36 points.
Output points: 24 points MITSUBISHI FX3UC-16MT/DSS-P4 Manual.
Power supply voltage: AC240-360V.
Output type: transistor output (source).
Built in CPU, power supply, input and output. While maintaining the convenience of FX1N while improving performance.
Special adaptor and function expansion board can be installed and used FX3 series.
High speed operation.
Basic instructions: 0.21 s/ instruction.
Application instruction: 0.5 s/ instruction.
Large capacity memory.
Built in program memory 32000 steps.
EEPROM memory cartridge with program transfer function. Input / output form: relay output.
Output points: 16 points.
DC5V internal consumption current: 100mA.
DC24V internal consumption current: 125mA.
In order to extend the input output of the device.
Also has a built-in power supply products.
The maximum number of points for the input and output is 256.
Expansion module: up to 16 units (inn addition to the power expansion module)
The total number of CC-Link, AnyWireASLINK, and Bitty series of remote I/O is 512 points FX3UC-16MT/DSS-P4 USER'S MANUAL. Power: 400kw.
Voltage: 400V.
The power factor of the input power factor is up to 0.999 and above (100% load) FX3UC-16MT/DSS-P4 USER'S MANUAL.
Can be connected to multiple inverters, to achieve a common DC bus mode.
Equipped with standard power retrogradation function.